Memoirs of the Faculty of Engineering, Yamaguchi University

Back to Top

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 34 Issue 2
published_at 1984

Study on Grooving Wear of Cutting Tool (2nd report)

切削工具の境界摩耗に関する研究(第 2 報)
Fujita Takeo
Kitagawa Ryozo
Okusa Kitao
fulltext
1.07 MB
KJ00000156509.pdf
Descriptions
Studies on grooving wear of cutting tool were continuously made after 1st report. In this study, the influencies of bur of workpiece at boundary portion and state of chip flow on grooving wear formation of tool at boundary portion were mainly examined in machining of stainless steel SUS304. The extent of bur formation was changed by changing tool rake angle and controlling contact length between tool rake face and chip. From this study, it is found that the influence of bur of workpiece on grooving wear formation is remarkable, and the extent of influence of bur on groove formation in case of machining SUS304 which the grooving wear is mainly caused by adhesive action between tool and work materials is larger than in case of carbon steel S55C which the grooving wear is mainly caused by the action of mechanical friction.