Contents Menu

Study on Grooving Wear of Cutting Tool (2nd report)

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 34 Issue 2 Page 241-247
published_at 1984
KJ00000156509.pdf
[fulltext] 1.07 MB
Title
切削工具の境界摩耗に関する研究(第 2 報)
Study on Grooving Wear of Cutting Tool (2nd report)
Creators Fujita Takeo
Creators Kitagawa Ryozo
Creators Okusa Kitao
Source Identifiers
Studies on grooving wear of cutting tool were continuously made after 1st report. In this study, the influencies of bur of workpiece at boundary portion and state of chip flow on grooving wear formation of tool at boundary portion were mainly examined in machining of stainless steel SUS304. The extent of bur formation was changed by changing tool rake angle and controlling contact length between tool rake face and chip. From this study, it is found that the influence of bur of workpiece on grooving wear formation is remarkable, and the extent of influence of bur on groove formation in case of machining SUS304 which the grooving wear is mainly caused by adhesive action between tool and work materials is larger than in case of carbon steel S55C which the grooving wear is mainly caused by the action of mechanical friction.
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1984
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部