Memoirs of the Faculty of Engineering, Yamaguchi University

Back to Top
Permalink : https://petit.lib.yamaguchi-u.ac.jp/13932
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 21 Issue 3
published_at 1971

Study on Effect of Cutting Fluid (3rd report) : Facing Cut by High Speed Steel Tool

油剤の効果に関する研究(第3報) : 高速度鋼工具による正面切削
Okusa Kitao
Yamamoto Eiji
fulltext
251 KB
KJ00000155831.pdf
About This Article
Descriptions
The effects of cutting fluids on cutting force, surface roughness and so on in orthogonal cutting by a planer were reported in previous papers. In this report, those effects and the influence on tool failure are investigated using high speed steel tool in the facing cut by a lathe. As the facing cut is often used in turning operation, the results by this test procedure have the practical meaning. And also the significance of quick and inexpensive facing test method is discussed.
Creator Keywords
(Bi, Pb)_2Sr_2Ca_2Cu_3O_y
Ag addition
Jc
intermediate cold press
Other Article
On the Response of Asphalt Mixtures under Repeated Impulsive Load
PP. 227 - 232
Research in Connection with Proportion Plan of Asphalt Mixture
PP. 233 - 241
On the Young's Modulus of Different Form for Standard Size
PP. 243 - 248
An Analysis of Mutual Inductance between the Skewed Conductors
PP. 249 - 254
Calculation of Mutual Inductance between a Circular Coil with a Rectangular Cross Section in front of a Conductor Plate and its Image Coil (1st report)
PP. 255 - 262
A Study of Frequency Characteristics of Effective Impedance of a Coil facing to a Thick Non-ferromagnetic Metal Plate (2nd Report)
PP. 263 - 270
Study on the Vibration of Discharging Electrode for the Electrostatic Precipitator (1st Report)
PP. 271 - 279
Study on the Brushless Motor (2nd Report)
PP. 281 - 286
Study on Effect of Cutting Fluid (3rd report) : Facing Cut by High Speed Steel Tool
PP. 287 - 290
Study on Effect of Cutting Fluid (4th report) : Cutting Ability Test of High Speed Steel by Facing Cut
PP. 291 - 295
On the Cutting of Ductile Roll (1st Report) : The Selection of the Suitable Tool by Life Test
PP. 297 - 302
Effect of the Angle of Engagement and the Angle of Disengagement on the Chipping Failure of the Fly Cutter : Face Milling of Cylindrical Workpiece (3rd Report)
PP. 303 - 309
Experimental Research on the Effect of Cutting Fluid (1st report) : In the Case of Cylindrical Turning of SCM Steel by High Speed Steel Tool
PP. 311 - 318
Studies on Utilization of Electric Furnace Slag as Sand in Cement Mortar
PP. 319 - 324