Memoirs of the Faculty of Engineering, Yamaguchi University

Back to Top
Permalink : https://petit.lib.yamaguchi-u.ac.jp/16024
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 20 Issue 1
published_at 1969

On the Statistical Properties of Picture Signals

画像信号の統計的性質について
Kirihara Akio
Fujimoto Tsutomu
fulltext
777 KB
KJ00002361184.pdf
About This Article
Descriptions
There are many reports with respect to the statistics of television signals, but they have some questionable points in appling to standard TV signals. For example, E. R. Kretzmer has measured the autocorrelation function without limitting bandwidth to 5MHz. So we have built the digital type data punching equipment, measured some statistics of picture signals, and obtained some results.
Other Article
The Chemical Durability of P_2O_5-Na_2O System and P_2O_5-Na_2O-Al_2O_3 System Glasses
PP. 1 - 9
Obserbation of SiO_2-Na_2O System Glass Forming Reaction : NaOH as the Source of Na
PP. 11 - 16
The Chemical Durability of B_2O_3-SiO_2-Na_2O System Glasses
PP. 17 - 27
On the Experimental Study of Crushed Stone Concrete
PP. 29 - 35
A Study of Artificial Light Weight Aggregate Concrete
PP. 37 - 49
Experimental Studies of Seismic Active Earth Pressure
PP. 51 - 64
Shear Strength of Sand under Pulsating Loading Condition
PP. 65 - 69
Selective Withdrawal of Lower Fluid Layer from Stratified Field through Sluice Gate
PP. 71 - 81
On the Scoure around Circular Cylinder
PP. 83 - 90
Self Inductance of a Circular Loop of Wire near a Conductor
PP. 91 - 94
Self Inductance of a Spiral Coil near a Conductor
PP. 95 - 98
On the Statistical Properties of Picture Signals
PP. 99 - 104
Supercooled-Al Transformer
PP. 105 - 112
Study on Machining of Stainless Steel (1st report) : Selection of Suitable Tool Material for Turning
PP. 113 - 120
Study on Machining of Stainless Steel (2nd report) : Selection of Suitable Tool Material and Tool Geometry for Face Milling
PP. 121 - 132
Study on Effect of Cutting Fluid (1st report) : Orthogonal Cutting on Various Materials by High Speed Steel Tool
PP. 133 - 141
Study on Effect of Cutting Fluid (2nd report) : Influence of Cutting Fluid on Surface Finish
PP. 143 - 149
On the Periodity Appeared in the Variation of the Flow-out Quantity of Granules Flowing-out from the Hopper (Part 1)
PP. 151 - 175
Hot Machining of Titanium
PP. 177 - 184
Research on Pitting Strength under Rolling Contact of a Structual Mild Steel
PP. 185 - 193