Memoirs of the Faculty of Engineering, Yamaguchi University

Back to Top
Permalink : https://petit.lib.yamaguchi-u.ac.jp/16023
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 20 Issue 1
published_at 1969

Self Inductance of a Spiral Coil near a Conductor

導体に接近したうず巻コイルのインダクタンス
Takehira Nobuo
Osada Teturo
Nagashima Hironobu
fulltext
208 KB
KJ00002361183.pdf
About This Article
Descriptions
Regarding a spiral coil as a gathering of many circular loops of wire, we calculated its self inductance and mutual inductance between two spiral coils of the same shape. We put the spiral coil in parallel with a conductor and then measured the inductance satisfying the condition that the conductor is a perfect conductor. Experimental values agreed well with the theoretical results.
Other Article
The Chemical Durability of P_2O_5-Na_2O System and P_2O_5-Na_2O-Al_2O_3 System Glasses
PP. 1 - 9
Obserbation of SiO_2-Na_2O System Glass Forming Reaction : NaOH as the Source of Na
PP. 11 - 16
The Chemical Durability of B_2O_3-SiO_2-Na_2O System Glasses
PP. 17 - 27
On the Experimental Study of Crushed Stone Concrete
PP. 29 - 35
A Study of Artificial Light Weight Aggregate Concrete
PP. 37 - 49
Experimental Studies of Seismic Active Earth Pressure
PP. 51 - 64
Shear Strength of Sand under Pulsating Loading Condition
PP. 65 - 69
Selective Withdrawal of Lower Fluid Layer from Stratified Field through Sluice Gate
PP. 71 - 81
On the Scoure around Circular Cylinder
PP. 83 - 90
Self Inductance of a Circular Loop of Wire near a Conductor
PP. 91 - 94
Self Inductance of a Spiral Coil near a Conductor
PP. 95 - 98
On the Statistical Properties of Picture Signals
PP. 99 - 104
Supercooled-Al Transformer
PP. 105 - 112
Study on Machining of Stainless Steel (1st report) : Selection of Suitable Tool Material for Turning
PP. 113 - 120
Study on Machining of Stainless Steel (2nd report) : Selection of Suitable Tool Material and Tool Geometry for Face Milling
PP. 121 - 132
Study on Effect of Cutting Fluid (1st report) : Orthogonal Cutting on Various Materials by High Speed Steel Tool
PP. 133 - 141
Study on Effect of Cutting Fluid (2nd report) : Influence of Cutting Fluid on Surface Finish
PP. 143 - 149
On the Periodity Appeared in the Variation of the Flow-out Quantity of Granules Flowing-out from the Hopper (Part 1)
PP. 151 - 175
Hot Machining of Titanium
PP. 177 - 184
Research on Pitting Strength under Rolling Contact of a Structual Mild Steel
PP. 185 - 193