Memoirs of the Faculty of Engineering, Yamaguchi University

Back to Top
Permalink : https://petit.lib.yamaguchi-u.ac.jp/14838
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 20 Issue 1
published_at 1969

A Study of Artificial Light Weight Aggregate Concrete

人工軽量骨材コンクリートの一考察
Kagami Hifumi
Hasegawa Hiroshi
Kaneyuki Keiji
fulltext
1.1 MB
KJ00002361177.pdf
About This Article
Descriptions
According to scarcity of gravel at present in Japan, the crushed stone and artificial light weight gravel have greatly used for concrete. It is a report that the authors researched some properties for artificial light weight conerete and its applicable values by use of several fine aggregates and the kinds of fine aggregate related to the workability, some properties of those on the experimental results.
Other Article
The Chemical Durability of P_2O_5-Na_2O System and P_2O_5-Na_2O-Al_2O_3 System Glasses
PP. 1 - 9
Obserbation of SiO_2-Na_2O System Glass Forming Reaction : NaOH as the Source of Na
PP. 11 - 16
The Chemical Durability of B_2O_3-SiO_2-Na_2O System Glasses
PP. 17 - 27
On the Experimental Study of Crushed Stone Concrete
PP. 29 - 35
A Study of Artificial Light Weight Aggregate Concrete
PP. 37 - 49
Experimental Studies of Seismic Active Earth Pressure
PP. 51 - 64
Shear Strength of Sand under Pulsating Loading Condition
PP. 65 - 69
Selective Withdrawal of Lower Fluid Layer from Stratified Field through Sluice Gate
PP. 71 - 81
On the Scoure around Circular Cylinder
PP. 83 - 90
Self Inductance of a Circular Loop of Wire near a Conductor
PP. 91 - 94
Self Inductance of a Spiral Coil near a Conductor
PP. 95 - 98
On the Statistical Properties of Picture Signals
PP. 99 - 104
Supercooled-Al Transformer
PP. 105 - 112
Study on Machining of Stainless Steel (1st report) : Selection of Suitable Tool Material for Turning
PP. 113 - 120
Study on Machining of Stainless Steel (2nd report) : Selection of Suitable Tool Material and Tool Geometry for Face Milling
PP. 121 - 132
Study on Effect of Cutting Fluid (1st report) : Orthogonal Cutting on Various Materials by High Speed Steel Tool
PP. 133 - 141
Study on Effect of Cutting Fluid (2nd report) : Influence of Cutting Fluid on Surface Finish
PP. 143 - 149
On the Periodity Appeared in the Variation of the Flow-out Quantity of Granules Flowing-out from the Hopper (Part 1)
PP. 151 - 175
Hot Machining of Titanium
PP. 177 - 184
Research on Pitting Strength under Rolling Contact of a Structual Mild Steel
PP. 185 - 193