Study on Hot Machining (3rd report) : Cutting Resistance
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 19 Issue 1
Page 5-9
published_at 1968
Title
高温切削に関する研究(第3報) : -切削抵抗-
Study on Hot Machining (3rd report) : Cutting Resistance
Creators
Taniguchi Masaki
Creators
Seto Masafumi
Source Identifiers
This is a report on cutting resistance examined in various cases of hot machining of metallic materials. Three kinds of metallic materials used in this experiment were S45C carbon steel, 18-8 stainless steel, and 13 Cr stainless steel, whose tools had plus rake and minus one. And the following conclusion was formed. 1) In case of S45C and 13 Cr stainless steel, the heating effect hardly comes about in high speed but conspicuously in low speed. In other words, the cutting resistance decreases and at the same time the vibration does as well, and the state of cutting is steady. 2) In case of 18-8 stainless steel the heating effect hardly comes about in high speed. On the contrary cutting resistance increases in low speed as additional heat, and the state of cutting becomes unsteady. 3) In case of S45C and 13 Cr stainless steel, cutting resistance in hot machining increases in proportion to feeding. 4) In hot machining cutting resistance is less in using plus rake than in using minus one.
Languages
jpn
Resource Type
departmental bulletin paper
Publishers
山口大学工学部
Date Issued
1968
File Version
Version of Record
Access Rights
open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools
工学部