Machining of Titanium and its Alloy (1st Report)
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 21 Issue 1
Page 101-112
published_at 1970
Title
チタンおよびチタン合金の切削(第1報)
Machining of Titanium and its Alloy (1st Report)
Creators
Taniguchi Masaki
Creators
Fujita Takeo
Source Identifiers
Creator Keywords
engineering rock mechanics
application codes
numerical analysis
tunnel
slope
Titanium and its alloy to have excellent heat resisting and anti-corrosion properties are used for aerospace industry and many parts of chemical equipments, but they are hard to machine. Machining property of them is studied by the observation of tool failure, cutting resistance and tool life through hot-machining and normal machining. 1) Titanium alloy shows lower cutting resistance through hot-machining than normal machining, while titanium shows higher. 2) The failure of ceramics tool through hot-machining is larger than normal machining. 3) Sintered carbide (K-type), not contained TiC and TaC, is the best to machine the titanium and its alloy.
Languages
jpn
Resource Type
departmental bulletin paper
Publishers
山口大学工学部
Date Issued
1970
File Version
Version of Record
Access Rights
open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools
工学部