Contents Menu

Study on Effect of Cutting Fluid (2nd report) : Influence of Cutting Fluid on Surface Finish

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 20 Issue 1 Page 143-149
published_at 1969
KJ00002361189.pdf
[fulltext] 778 KB
Title
油剤の効果に関する研究(第2報) : 油剤の表面あらさにおよぼす影響
Study on Effect of Cutting Fluid (2nd report) : Influence of Cutting Fluid on Surface Finish
Creators Okusa Kitao
Creators Yamamoto Eiji
Creators Masudomi Masayuki
Source Identifiers
This is a report on surface finish examined with various cutting fluids. The relation between the surface finish and fluctuation of cutting force is also examined. The cutting fluids and workpiece materials in this report are the same as in the 1st report except the cast iron. The results obtained are as follows. 1. In such a low cutting speed as V=10m/min, the magnitude of surface roughness is a very large value. It is found that that the surface roughness also decreases with cutting fluids when the type of chip approaches the flow type and a less built-up edge occus. The effect of the mineral oil base is greater than water and water base. 2. The fluctuation of cutting force and surface finish are in the close relation.
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1969
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部