Resolution of the Tool Force Vector in Turning
Memoirs of the Faculty of Engineering, Yamaguchi University Volume 29 Issue 2
Page 283-289
published_at 1979
Title
切削抵抗の構成要素について
Resolution of the Tool Force Vector in Turning
Creators
Sakai Yoshiro
Creators
Watano Toyomitsu
Creators
Okusa Kitao
Source Identifiers
Chip control is one of the major problems in turning operation. The tool force as a vector includes much information about the direction of chip flow and the condition of chip formation. From the above point of view, the behavior of the tool force is discussed. It is found that the nonlinearity in the increase of the tool force with feed is mainly due to the cutting action at the corner and that the power spectrum of the fluctuation in the tool force reproduces well the chip breaking condition in operation. An equation is also proposed which governs the behavior of the tool force.
Languages
jpn
Resource Type
departmental bulletin paper
Publishers
山口大学工学部
Date Issued
1979
File Version
Version of Record
Access Rights
open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools
工学部