Contents Menu

Study on Hot Machining (2nd Report)

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 16 Issue 1 Page 53-59
published_at 1965
KJ00002361159.pdf
[fulltext] 1.65 MB
Title
高温切削に関する研究(第2報)
Study on Hot Machining (2nd Report)
Creators Taniguchi Masaki
Creators Seto Masafumi
Source Identifiers
In this report, surface roughness and tool wear when 18-8 stainless steel and 13Cr stainless steel were cut with ceramic tool under Local Electric Resisitance Heating are shown. The results of these experiments are as follows. (1) A better surface roughness is expected of both of the work materials when this method is used. (2) When this method is used, cratering for 18-8 stainless steel decreases. But for 13Cr stainless steel, cratering little decreases. (3) When machining 18-8 stainless steel and 13Cr stainless steel with ceramic tool, cutting speed must be kept at a higher point than 100m/min.
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1965
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部