Contents Menu

Study on Grindabilty of Cutting Tool Materials (4rd Report) : Grinding Cracks of Sintered Carbide Grades

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 20 Issue 3 Page 433-439
published_at 1970
KJ00000155757.pdf
[fulltext] 543 KB
Title
切削工具材の被研削性に関する研究(第4報) : 各種超硬合金材の研削クラック
Study on Grindabilty of Cutting Tool Materials (4rd Report) : Grinding Cracks of Sintered Carbide Grades
Creators Okusa Kitao
Creators Yamamoto Eiji
Creators Masudomi Masayuki
Source Identifiers
Sintered carbides are superior in wear resistance to high speed steels, but they are very brittle. Therefore they are apt to be cracked in grinding operation. The grinding cracks are an important factor in grinding sintered carbides. They affect the cutting ability on the one hand, affecting grinding ratio on the other hand. Dry grinding operation of sintered carbides is done with plane grinding machine. The number and the depth of grinding cracks are examined respectively on the ground surface in case of the grinding wheel GC120K9V. The results obtained are as follows. 1. Grinding cracks occur easily in the low toughness sintered carbides, especially in the sintered carbides containing TiC and TaC. 2. The high grade of sintered carbides in more than the low grade in the number of grinding cracks. 3. Grinding cracks of the grade K01,K05 are very deep, the others are shallow.
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1970
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部