Contents Menu

A Study on the Behaviour of Residual Strain during Cutting Process : in Machining Ductile Material

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 38 Issue 1 Page 9-15
published_at 1987
KJ00000156654.pdf
[fulltext] 580 KB
Title
切削歪の残留挙動について : 延性材の切削
A Study on the Behaviour of Residual Strain during Cutting Process : in Machining Ductile Material
Creators Kumabe Akira
Creators Yamamoto Kouji
Creators Kitagawa Ryozo
Source Identifiers
Detailed studies on the deformation of a workpiece during cutting processes have already been carried out. But a few of them have ever dealt with the separation of the component of the instantaneous cutting strain and that of the residual one in the following stage. In order to separate them, it requires to measure the strain quantitatively. The authors have reported the results of the investigation of the cutting strain measured by the photoelastic coating method. In this paper, the behaviour of the strain in the ductile material during the orthogonal cutting process was investigated by the same method. The results obtained through this study are as follows. 1. The comportment of the cutting strain in the ductile material was understood by means of the photoelastic coating method. 2. It was found that the behaviour of the cutting strain in the strain hardening material was similar to that of the elastic material.
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1987
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部