Experimental Research on the Effect of Cutting Fluid (1st report) : In the Case of Cylindrical Turning of SCM Steel by High Speed Steel Tool

切削油剤の効果に関する実験的研究(第1報) : 高速度鋼工具によるSCM鋼の長手円筒切削の場合

Experimental Research on the Effect of Cutting Fluid (1st report) : In the Case of Cylindrical Turning of SCM Steel by High Speed Steel Tool

Creators Okusa Kitao

Creators Yamamoto Eiji

Creators Matsumoto Isao

Five kinds of commercial fluids are examind in the short time cutting test using the high speed steel SKH 5 and SCM steel. The effect of cutting fluids upon the cutting temperature, the cutting force and the built up edge are obtained in this test. The representative two kinds of the cutting fluids in the above test are used in the long time cutting test to estimate the effect upon the tool life. The results show that cutting temperature and cutting force in wet cutting are lower than those in dry cutting, but tool life does not always extend in wet cutting against expectation. It is therefore noticed that the cutting fluids should be selected in accordance with the cutting purpose.

[ISSN]0372-7661

[NCID]AN00244228