コンテンツメニュー

Study on Grooving Wear of Cutting Tool (3rd Report)

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 35 Issue 1 Page 11-18
published_at 1984
KJ00000156523.pdf
[fulltext] 994 KB
Title
切削工具の境界摩耗に関する研究(第 3 報)
Study on Grooving Wear of Cutting Tool (3rd Report)
Creators Fujita Takeo
Creators Kitagawa Ryozo
Creators Okusa Kitao
Source Identifiers
Grooving wear on bounday portion of tools in machining SUS 304 is mainly caused by adhesive action between tool and work materials from 1st and 2nd reports. It may be considered that the above adhesive action is influenced by adhesion of Co in tool material and Ni in work marterial. Accordingly, in order to investigate influences of tool material on grooving wear, turning tests are performed with various carbide tools including different amount of Co, which are specially made for this study. From this study, following resuts are mainly obtained. (1) Grooving wears in case of WC-Co type carbide tools are mainly caused by high temperature after adhesive action of tool material and work material because their tool materials have not enough heat resistance. In case of WC-Co-TiC-TaC type carbide tools, grooving wears are caused by chipping after adhesion because their tool materials have not enough toughness. (2) In case of machining SUS 304 using WC-Co type carbide tools, the criterion of tool life must not be taken by flank wear but grooving wear.
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1984
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部